11 Measures to Spray Paint Your Car Like the Professionals - Auto Bodywork Paint Repair

11 Steps to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair

You may be surprised to see only how to spray car paint really can not be difficult. That doesn't mean that you can just grab a tin of paint and go at it. There are some principles you need to understand. Both in application and the preparation.

Step A:

Prepare by assembling all of your things that you are going to need. Ensure your surrounding area is protected against any potential over spray. For other areas cover nicely with paper and masking tape.

Measure B:

You may have to analyze the car carefully. These will have to be sanded with 300 grit sand paper. It also enables the spray auto paint to stick better. Make certain all the dust dirt and debris are taken from the vehicle, once you have finished sanding. It's critical that the car be absolutely clean.

Step C:

You will need to apply a primer. This will make sure that you get an overall even coating of your colored paint plus helps the paint to adhere nicely. Ensure you apply light layers and allow for drying in between, when you spray the primer. How exactly to spray car paint takes a little getting used to.

Step D:

Now you're pretty well to the point where you are around ready to spray on the shade. Before you begin with the automobile in either case, make several practice strokes on an item. Begin the passes with the paint without hesitation, once you happen to be ready. You will end up getting uneven coverage, if you hold the spray can or gun in one area and perhaps the paint will run. If this happens you have an important repair job on your had. You'll most probably have directions as to how exactly to spray auto paint using the equipment or spray cans.

Step E:

It's up to you whether you want to wet sand between coats of colour and primer paints. You may want to study this alternative on the web, or check with someone that is comfortable with just how to spray on auto paint

Step F:

You are down to the finishing touches once you are completely satisfied with the color. You may now need to apply several clear coatings. This can give the shine and finished appearance to the auto along with protect the finish. It will be up to you personally although probably two coats will be adequate. Make absolutely sure it truly is dry in between coats.

Step G:

Once more, you've got the choice of wet sanding if you prefer. Again, I would recommend you request the guidance of individuals which are comfortable with how to paint a car. If you determine to follow this step then you need with these grits in this sequence. This will remove spots that'll not be overly light in the clear coating application.

Step H:



Now you'll desire to using a rubbing compound to buff the surface so you could use a 2000 grit to remove any scratches.

Step I:

You should now buff the surface. To try this just use a medium cut polish.

Step J:

As a final touch, you Alloy Wheel Repair Hornchurch may want to apply a couple of coats of wax.

Write a comment

Comments: 0